Aluminum Electrolytic Capacitors
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
computer science crazy
Super Moderator

Posts: 3,048
Joined: Dec 2008
17-09-2009, 12:47 AM

Aluminum Electrolytic Capacitors

Aluminium electrolytic capacitors are widely used in power supply circuitry of electronic equipment as there after several advantages over other types of capacitances. The selection of a capacitor for an application without knowing the basics may result in unreliable performance of the equipment due to expanitor problems. It may lead to customer dissatisfaction and damage market to potential or the image of a reputed company. The aluminium eletrolytic capacitors are suitable to be used when a great capacitance value is required in a very small size. The volume of an electrolytic capacitor is more than 10 times less than a film one considering the same rated voltage and capacitance. The cost per F is also less when compared with all other capacitors.


An aluminium electrolytic capacitor is composed of high-purity, thin aluminium foil (0.05 to I mm thick) having a dieletric anidation on its surface to prevent current flow in one direction. This outs as anode. Another these two aluminium coils is an electrolytic impregnated paper, which cuts as the dieletric. Since the capacitors is inversely propotional to the dieletric thiclenen. And the dieletric thicknen is propotional to the forming voltage, the relationship between capacitance and cerming voltage is.

Capacitance X Forming Voltage = Constant.

Aluminium tabs attached to the anode and cathode coils act as the positive and negative leads of the capacitor respectively. The entire element is sealed into an aluminium can by using rubber, bakelite or phenolic plastic. The construction of an aluminum electrolytic capacitor is the following:

The anode (A):

The anode is formed by an aluminium foil of extreme purity. The effective surface area of the coil is greatly enlarged (by a factor upto 200) by electrochemical etching in order to achive the maximum possible capacitance values.
The dieletric (O):

The aluminum foil (A) is covered by a very thin oxidised layer of aluminium oride (O=Al O3. This oxide is obtained by means of an eletro chemical process. The typical value of forming voltage is 1.2 nm/v. the oxide with stands a high electric field strength and it has a high dielectric constant. Aluminium oxide is therefore well suited as a capacitor dieletric in a polar capacitor. The A12O3 has a high insulation resistance for voltages lower than the forming voltage. The oxide layer consistitutes a nonlinear voltage dependent resistance: the current increases more steeply as the voltage increases

The electrolytic Paper, cathode (C,K)

The negative electrode is a liquid electrolyte absorbed in a paper. The paper also acts as a spacer between the positive foil carrying the dieletric layer and the opposite Al-foil ( the negative Coil) acting as a contact medium to the eletrolyte. The cathode foil serves as a large contact area for passing current to the operating eletrolyte. Bipolar Al electrolytic capacitors are also available. In this designs both the anode foil and cathode foil are anodized. The cathode foil has the same capacitance rating as the anode foil. This construction allows for operation of direct voltage of either polarity as well as operation of purely alternating voltages. Since it causes internal heating the applied atternating voltage must be kept considerably below the direct voltage rating. Since we have the series connection of two capacitor elements, the total capacitance is equal to only half the individual capacitance value. So compared to polar capacitor, a bipolar capacitor requires upto twice the volume for the same total capacitance.
Use Search at wisely To Get Information About Project Topic and Seminar ideas with report/source code along pdf and ppt presenaion

Important Note..!

If you are not satisfied with above reply ,..Please


So that we will collect data for you and will made reply to the request....OR try below "QUICK REPLY" box to add a reply to this page
Tagged Pages: project on aluminium electrolytic capacitor in pdf, aluminium electrolytic capacitor seminar ppt, aluminium electrolytic capacitors, aluminium electolytic capacitors, electrical engineering seminar topic on latest capacitors, abstract for aluminium electrolytic capacitor, electronics seminar capacitor,
Popular Searches: aluminium smelting seminar ppt, electrolytic hydogen, 3 f 103j capacitors, seminar topic about electrolytic, aluminum alloys project topics, zoop aluminum, electrolytic hytrogen,

Quick Reply
Type your reply to this message here.

Image Verification
Please enter the text contained within the image into the text box below it. This process is used to prevent automated spam bots.
Image Verification
(case insensitive)

Possibly Related Threads...
Thread Author Replies Views Last Post
  ultra capacitors computer science crazy 10 6,779 10-12-2012, 11:48 AM
Last Post: seminar tips
  Super Capacitors Report project girl 0 326 22-11-2012, 01:11 PM
Last Post: project girl
  1 Day Robot Building (MC40A + Aluminum Base) for Edubot 2.0 seminar flower 0 561 14-08-2012, 03:20 PM
Last Post: seminar flower
  Super Capacitors Energy Storage System For Power Quality Improvement seminar ideas 0 458 04-05-2012, 01:57 PM
Last Post: seminar ideas
  Integrated Implantable Stimulator without Off-Chip Blocking-Capacitors seminarsonly 3 2,435 09-12-2010, 04:18 PM
Last Post: science projects buddy
Last Post: seminar surveyer