Carbon Nanotube Flow Sensors
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Computer Science Clay
Active In SP

Posts: 712
Joined: Jan 2009
01-03-2009, 01:50 PM

Carbon Nanotube Flow Sensors

Direct generation of measurable voltages and currents is possible when a fluids flows over a variety of solids even at the modest speed of a few meters per second. In case of gases underlying mechanism is an interesting interplay of Bernoulli's principle and the See beck effect: Pressure differences along streamlines give rise to temperature differences across the sample; these in turn produce the measured voltage. The electrical signal is quadratically dependent on the Mach number M and proportional to the Seebeck coefficient of the solids.

This discovery was made by professor Ajay sood and his student Shankar Gosh of IISC Bangalore, they had previously discovered that the flow of liquids, even at low speeds ranging from 10 -1 meter/second to 10 -7 m/s (that is, over six orders of magnitude), through bundles of atomic-scale straw-like tubes of carbon known as nanotubes, generated tens of micro volts across the tubes in the direction of the flow of the liquid. Results of experiment done by Professor Sood and Ghosh show that gas flaw sensors and energy conversion devices can be constructed based on direct generation of electrical signals. The experiment was done on single wall carbon nanotubes (SWNT).These effect is not confined to nanotubes alone these are also observed in doped semiconductors and metals.

The observed effect immediately suggests the following technology application, namely gas flow sensors to measure gas velocities from the electrical signal generated. Unlike the existing gas flow sensors, which are based on heat transfer mechanisms from an electrically heated sensor to the fluid, a device based on this newly discovered effect would be an active gas flow sensor that gives a direct electrical response to the gas flow. One of the possible applications can be in the field of aerodynamics; several local sensors could be mounted on the aircraft body or aerofoil to measure streamline velocities and the effect of drag forces. Energy conversion devices can be constructed based on direct generation of electrical signals i.e. if one is able to cascade millions these tubes electric energy can be produced.

As the state of art moves towards the atomic scales, sensing presents a major hurdle. The discovery of carbon nanotubes by Sujio Iijima at NEC, Japan in 1991 has provided new channels towards this end. A carbon nanotube (CNT) is a sheet of graphene which has been rolled up and capped with fullerenes at the end. The nanotubes are exceptionally strong, have excellent thermal conductivity, are chemically inert and have interesting electronic properties which depend on its chirality. The main reason for the popularity of the CNTs is their unique properties. Nanotubes are very strong, mechanically robust, and have a high Young's modulus and aspect ratio. These properties have been studied experimentally as well as using numerical tools. Bandgap of CNTs is in the range of 0~100 meV, and hence they can behave as both metals and semiconductors.

A lot of factors like the presence of a chemical species, mechanical deformation and magnetic field can cause significant changes in the band gap, which consequently affect the conductance of the CNTs. Its unique electronic properties coupled with its strong mechanical strength are exploited as various sensors. And now with the discovery of a new property of flow induced voltage exhibited by nanotubes discovered by two Indian scientists recently, has added another dimension to micro sensing devices.

CNT Electronic Properties
Electrically CNTs are both semiconductor and metallic in nature which is determined by the type of nanotube, its chiral angle, diameter, relation between the tube indices etc. The electronic properties structure and properties is based on the two dimensional structure of Graphene. For instance if the tube indices, n and m, satisfies the condition n-m=3q where q is and integer it behaves as a metal. Metal, in the sense that it has zero band gap energy. But in case of armchair (where n=m) the Fermi level crosses i.e. the band gap energy merges. Otherwise it is expected the properties of tube will be that of semiconductor. The table below (Table 1) is the observations of experiments done on nanotubes by Scanning tunneling microscope (STM) and Scanning tunneling spectroscopes (STS).

Fluid Flow Through Carbon

Recently there has been extensive study on the effect of fluid flow through nanotubes, which is a part of an ongoing effort worldwide to have a representative in the microscopic nano-world of all the sensing elements in our present macroscopic world. Indian Institute of Science has a major contribution in this regard. It was theoretically predicted that flow of liquid medium would lead to generation of flow-induced voltage. This was experimentally established by two Indian scientist at IISc. Only effect of liquid was theoretically investigated and established experimentally, but effect of gas flow over nanotubes were not investigated, until A.K Sood and Shankar Ghosh of IISc investigated it experimentally and provided theoretical explanation for it. The same effect as in case of liquid was observed, but for entirely different reason. These results have interesting application in biotechnology and can be used in sensing application. Micro devices can be powered by exploiting these properties.
Use Search at wisely To Get Information About Project Topic and Seminar ideas with report/source code along pdf and ppt presenaion

Important Note..!

If you are not satisfied with above reply ,..Please


So that we will collect data for you and will made reply to the request....OR try below "QUICK REPLY" box to add a reply to this page
Tagged Pages: carbon nanotube flow sensors report, cnt flow sensors seminar report, nanotube gas sensor pdf,
Popular Searches: power point presentation for carbon nanotube topics in chemical engineering download, carbon nanotube flow sensors report, carbon nanotube polymer composites, carbon nanotube transistor seminar reports, carbon nanotube structure ppt, active carbon, nanotube in drug ppt,

Quick Reply
Type your reply to this message here.

Image Verification
Please enter the text contained within the image into the text box below it. This process is used to prevent automated spam bots.
Image Verification
(case insensitive)

Possibly Related Threads...
Thread Author Replies Views Last Post
  distributed power flow controller ppt jaseelati 0 258 21-01-2015, 03:21 PM
Last Post: jaseelati
  air flow detector project report jaseelati 0 250 10-01-2015, 03:19 PM
Last Post: jaseelati
  how does a street lamp work using microprocessors and sensors jaseelati 0 127 20-12-2014, 03:48 PM
Last Post: jaseelati
  WIRELESS INTEGRATED NETWORK SENSORS ppt study tips 0 472 27-08-2013, 03:06 PM
Last Post: study tips
  carbon nanotubes full report project reporter 24 20,954 27-08-2013, 02:02 PM
Last Post: kasi siva
  Acousto-Ultrasonic Optical Fiber Sensors PPT study tips 0 365 30-07-2013, 03:16 PM
Last Post: study tips
  A FACTS DEVICE DISTRIBUTED POWER-FLOW CONTROLLER (DPFC) seminar flower 5 3,314 29-07-2013, 10:31 AM
Last Post: study tips
  Seminar Report On Wearable Bio-Sensors mechanical wiki 2 2,951 25-06-2013, 02:52 PM
Last Post: study tips
  Development of a computer interface for a clamp-on ultrasonic flow meter pdf study tips 0 368 03-06-2013, 04:37 PM
Last Post: study tips
  SDP600 Series - Differential Pressure Sensors study tips 0 340 06-03-2013, 11:45 AM
Last Post: study tips