Zero power magnetic levitation using composite of magnetostrictive  piezoelectric ma
seminar class Active In SP Posts: 5,361 Joined: Feb 2011 
02032011, 03:34 PM
presented by: NIVEETH C niveeth.pptx (Size: 1.5 MB / Downloads: 56) Zero power magnetic levitation using composite of magnetostrictive  piezoelectric materials overview Introduction What is a composite? • Composite for magnetic force control • comparison • Experiments using composite only using composite and electromagnet Magnetic levitation • Inverse magnetostrictive effect • Joule loss • Zero power consumption during stationary • Control by the integral feedback • What is a composite? • Composite for magnetic force control • Dimensions Working… • When voltage is increased with fixed gap,flux changes as in (b) • Now the PZTs extends and reduces the compressive force on TerfenolD • Thus magnetic force increases • Since flux is conserved increase of flux in terfenol cause decrease in the gap • COMPARISON OF ELECTROMAGNET WITH COMPOSITE ELECTROMAGNET • It consists of coil with large no of turns of winding requires large power supply with high voltage. • The operation is accompanied with joule loss • Even when equipped with permanent magnet,the zero power is only valid at equilibrium state. COMPOSITE • It does not require large power supply because stack PZTs provide maximum performance at rating voltage. • Power supply should amplify the voltage,but does not have to be capable of providing large current. • The composite does not consume electric energy in static operation at any value of force.This is due to capacitive property of PZTs. • Levitation using composite • Yoke equations • F = Fo + dF= Fo + Kx *x +Kv*v Kxgradient of F with gap under fixed voltage Kvgradient of F with voltage under fixed gap • Kinetic equation mx·· +cx· +Kx*x +Kv*v =0 cdamping coefficient • Combination of composite and electromagnet Experimental set up Working • Control voltage is fed to PZTs from gap sensor through dcdc converter • To electromagnet through current amplifier • Converter is energized with a dry cell of 4.5v By varying the gap stationary under the fixed mass, the control outputs for electromagnet and composite are ic = Kpc *x + Kdc*x·+ Kic∫ic dt vp= Kpp*x + Kip ∫x dt • conclusion • Experiments on levitation was conducted and the gap at the levitation was successfully controlled by the voltage of the PZTs • It maintained zero power consumption in static state • Composite can be used for large loads too • Applications include high precision positioning and convey system • reference • T. Ueno, J. Qiu, and J. Tani, “Magnetic force control based on the inverse magnetostrictive effect,” IEEE Trans. Magn., vol. 40, no. 3, pp.1601–1605, May 2004. • T. Ueno, J. Qiu, and J. Tani, “New magnetic force control device with composite of giant magnetostrictive and piezoelectric materials,” IEEE Trans. Magn., vol. 39, no. 6, pp. 3534–3540, Nov. 2003. • T. Ueno and T. Higuchi, “Design of magnetostrictive/piezoelectric laminate composite for coilless magnetic force,” IEEE Trans. Magn. vol. 41, no. 4, pp. 1233–1237, Apr. 2005. • T. Ueno and T. Higuchi, “Zeropower magnetic levitation by magnetic force control device using lamination of magnetostrictive material and piezoelectric material,” in Ninth Int. Symp. Magnetic Bearings, 2004. 



Important Note..!
If you are not satisfied with above reply ,..PleaseASK HERE
So that we will collect data for you and will made reply to the request....OR try below "QUICK REPLY" box to add a reply to this pageTagged Pages: magnetic levitation force calculation, terfenop d in magnetic levitation, 5360 4 5v dry cell, 